共找到 125 條與 過(guò)程故障模式及影響分析 相關的標準，共 9 頁
This standard defines requirements for the identification@ assessment@ mitigation@ and prevention of risk in the manufacturing process through
Process Failure Mode and Effects Analysis (PFMEA) and Control Plans
Process Failure Mode and Effects Analysis (PFMEA) and Control Plans
本標準定義了通過在產品生命周期中應用工藝流程圖（PFD）、工藝失效模式及影響分析（PFMEA）和控制計劃來識別、評估、緩解和預防制造過程中的風險的要求。本標準與AS9100、AS9102、AS9103和AS9145的要求保持一致并協作。本標準中規定的要求適用于合同和適用的法規要求，且不替代這些要求
Process Failure Mode and Effects Analysis (PFMEA) and Control Plans
Potential Failure Mode and Effects Analysis in Design (Design FMEA) and Potential Failure Mode and Effects Analysis in Manufacturing and Assembly Processes (Process FMEA) Reference Manual
Nuclear power plant system failure mode, impact and hazard analysis guide
This Technical Report provides guidance on nuclear-specific issues when applying Failure Mode and Effects Analysis (FMEA) and related methods
Nuclear power plants - Instrumentation and control systems important to safety - Use of Failure Mode and Effects Analysis (FMEA) and related methods to support the justification of systems
Nuclear power plants - Instrumentation and control systems important to safety - Use of Failure Mode and Effects Analysis (FMEA) and related methods to support the justification of systems
本文件規定了系統性開展醫用電氣設備（ME設備）和醫用電氣系統（ME系統）失效模式、影響及危害度分析（FMECA）的程序和方法
Guidelines for Failure Mode Effects and Criticality Analysis of Medical Electrical Equipment
Recommended Failure Modes and Effects Analysis (FMEA) Practices for Non-Automobile Applications describes the basic procedures for performing
Recommended Failure Modes and Effects Analysis (FMEA) Practices for Non-Automobile Applications
Analysis techniques for system reliability - Procedure for failure mode and effects analysis (FMEA)
Potential Failure Mode and Effects Analysis in Design (Design Fmea), Potential Failure Mode and Effects Analysis in Manufacturing and Assembly Processes (Process Fmea), and Potential Failure Mode and
Biological treatment of drinking water to remove manganese (Mn) is an attractive option for some communities as it relies on less chemical inputs
Factors Affecting Manganese Removal during Biofiltration: A Full-scale and Bench-scale Analysis
Inspection procedure for establishment affected by major-accident hazards involving dangerous substances. Part 8: Assessment of the risk analysis
Potential Failure Mode and Effects Analysis (FMEA) Including Design FMEA, Supplemental FMEA-MSR, and Process FMEA
Plain bearings - Quality assurance of thin-walled half bearings - Design failure mode and effects analysis (ISO 12132:1999)
