共找到 150 條與 交流端口額定電壓 相關的標準，共 10 頁
Covers requirements for enclosures for the termination of cables and for the housing of live conductors in air, for use indoors or outdoors, at rated
Cable terminations and live conductors within air-filled enclosures (insulation co-ordination) for rated a.c. voltages from 7,2 kV up to and including 36 kV
1???Scope and object This part of IEC?61000 defines the immunity test methods and range of recommended basic test levels for electrical
Electromagnetic compatibility (EMC) - Testing and measurement techniques. Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity tests
ETSI TS 126 245-2007 全球移動通信系統(UMTS).透明端到端分組交換流業務(PSS).定時的文本格式(版本7.0.0).3GPP TS 26.245(版本7.0.0,第7次發布)
Universal Mobile Telecommunications System (UMTS); Transparent end-to-end Packet switched Streaming Service (PSS); Timed text format V7.0.0; 3GPP TS 26.245 version 7.0.0 Release 7
Electromagnetic compatibility (EMC). Part 4-13. Testing and measurement techniques. Harmonics and interharmonics including mains signalling at a.c. power port. Low frequency immunity tests
DTE and DCE of data networks for the transfer of binary data, call control signals and timing signals. This Recommendation applies to the functions
LIST OF DEFINITIONS FOR INTERCHANGE CIRCUITS BETWEEN DATA TERMINAL EQUIPMENT (DTE) AND DATA CIRCUIT-TERMINATING EQUIPMENT (DCE) ON PUBLIC DATA NETWORKS
Universal Mobile Telecommunications System (UMTS); LTE; 5G; Transparent end-to-end Packet switched Streaming Service (PSS); Timed text format (3GPP TS 26.245 version 17.0.0 Release 17)
This part of IEC 61000 defines the immunity test methods and range of recommended basic test levels for electrical and electronic equipment with rated
Electromagnetic compatibility (EMC) - Testing and measurement techniques - Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity tests
This part of IEC 61000 defines the immunity test methods and range of recommended basic test levels for electrical and electronic equipment
Electromagnetic compatibility (EMC) - Testing and measurement techniques - Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity tests - Test for immunity to harmonics and interharmonics including mains signall
Plugs, socket-outlets, vehicle connectors and vehicle inlets. Conductive charging of electric vehicles. Part 2. Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
Interface between Data Terminal Equipment (DTE) and Data Circuit- Terminating Equipment (DCE) for Start-Stop Transmission Services on Public Data
INTERFACE BETWEEN DATA TERMINAL EQUIPMENT (DTE) AND DATA CIRCUIT-TERMINATING EQUIPMENT (DCE) FOR START-STOP TRANSMISSION SERVICES ON PUBLIC DATA NETWORKS
Electromagnetic Compatibility (EMC) - Part 4-31: Testing and measurement techniques - AC mains ports broadband conducted disturbance immunity test (IEC 77B/726/CDV:2015); German version FprEN 61000-4-31:2015
Draft Document - Electromagnetic Compatibility (EMC) - Part 4-31: Testing and measurement techniques - AC mains ports broadband conducted disturbance immunity test (IEC 77B/726/CDV:2015); German version FprEN 61000-4-31:2015
Electromagnetic compatibility (EMC) - Part 4-31: Testing and measurement techniques - AC mains ports broadband conducted disturbance immunity test (IEC 61000-4-31:2016); German version EN 61000-4-31:2017
Electromagnetic compatibility (EMC) - Part 4-31: Testing and measurement techniques - AC mains ports broadband conducted disturbance immunity test (IEC 61000-4-31:2016); German version EN 61000-4-31:2017
Introduction (This introduction is not part of IEEE Std C37.081a-1997@ Supplement to IEEE Guide for Synthetic Fault Testing of AC High- Voltage
Supplement to IEEE Guide for Synthetic Fault Testing of AC High-Voltage Circuit Breakers Rated on a Symmetrical Current Basis 8.3.2: Recovery Voltage for Terminal Faults; Asymmetrical Short-Circuit Current
