GB/T 15395-1994 電子設備機柜通用技術條件

本標準規定了電子設備機柜的分類與標記，設計和制造的要求、試驗方法及檢驗規則。 本標準適用于雷達、測控、通信、計算機等地面、車載、艦載、機載用各種結構形式的電子設備機柜。

General technical specification for cabinet of electronic equipment

GB 9366-1988 攝像管線圈組件測試方法

Test method for camera tube coil assembly

DB44/T 2009-2017 移動終端電容式觸摸屏通用技術規范

本標準規定了移動終端電容式觸摸屏的術語和定義、要求、試驗方法、檢驗規則、標志、標簽、包裝、運輸和貯存。 本標準適用于以玻璃或膜材為主要基材，經黃光印刷或激光雕刻等工藝制成的各類結構的電容式觸摸屏（以下簡稱“觸摸屏”或“TP”（Touch Pannel））。

General technical specification for mobile terminal capacitive touch screen

ITU-T G.9979-2014 在電器和電子工程師學會(IEEE) 1905.1a-2014標準中的通用機制實施里包括適用的ITU-T建議(研究組15)

Implementation of the generic mechanism in the IEEE 1905.1a-2014 Standard to include applicable ITU-T Recommendations (Study Group 15)

CFR 47-90.537-2014 電信. 第90部分:私人土地移動無線電業務. 第R子部分:關于批準和使用758-775MHz和788-805MHz樂隊頻率的管理章程. 第90.537節:線槽要求.

(a) General use and State License channels. All systems using six or more narrowband channels in the 769–775 MHz and 799–805 MHz frequency bands must be trunked systems, except for those described in paragraph (b) of this section.

Telecommunication. Part90:Private land mobile radio services. Subpart R:Regulations governing the licensing and use of frequencies in the 758–775 and 788–805 MHz bands. Section90.537:Trunking requirement.

YD/T 641-2012 通信設備用低頻連接器技術要求及試驗方法

本標準規定了通信設備用低頻連接器的技術要求和試驗方法。本標準適用于3MHz及3MHz以下頻率的低頻連接器。

General requirements and test methods for low frequency connectors of telecommunication equipment

ITU-T Y.2902-2008 運營級開放環境組件.13號研究組

Recommendation ITU-T Y.2902 describes carrier grade open environment (CGOE) components, assigned to specific categories of the CGOE reference model, which may be used in commercial off-the-shelf components, suitable for implementation in next generation networks (NGNs).

Carrier grade open environment components Study Group 13

TIA J-STD-025-B-2-2007 合法授權的電子監督

The purpose of this addendum is to add the Carrier Identity information in the cdma2000PacketDataServingSystem message to the ANSI/J-STD-025-B standard to support a subscriber roaming in another network by providing the Carrier Identity. Paragraphs in

Lawfully Authorized Electronic Surveillance (LAES) ?Addendum 2 - Support for Carrier Identity Addendum to ANSI/J-STD-025-B

TIA J-STD-025-B-1-2006 合法授權的電子監督

The purpose of this addendum is to add the necessary Mobile Equipment IDentifier (MEID) information to ANSI/J-STD-025-B. Paragraphs in ANSI/J-STD- 025-B that are not shown remain the same. The section numbering in section 3 of this document aligns with

Lawfully Authorized Electronic Surveillance (LAES) Addendum 1朅ddition of Mobile Equipment IDentifier (MEID) Addendum to J-STD-025-B; This Standard is Available Simultaneously with J-STD-025, J-STD-025-A, and J-STD-025-B

TIA-1066-2006 CDMA2000 VoIP電子監視

LAES for cdma2000 VoIP

LAES for cdma2000 VoIP

DLA MS25046 REV B VALID NOTICE 2-2005 接線板雙頭螺栓的面板組裝

The activities above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http://assist.daps.dla.mil.

COVER ASSEMBLY, TERMINAL BLOCK TWO STUD

DLA MS25044 REV B VALID NOTICE 2-2005 雙頭螺栓接線端子板

The activities above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http://assist.daps.dla.mil.

TERMINAL BOARD TWO STUD

DLA MS35760 REV A VALID NOTICE 3-2005 (CD-307-A型軟線)軟線組裝

The activities above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at h_t_t_p_:_/_/_a_s_s_i_s_t_._d_a_p_s_._d_l_a_._m_i_l_

CORD ASSEMBLY, ELECTRICAL (CORD CD-307-A)

TIA-1042-2005 cdma2000 移動站的電子聲學推薦最低性能規范

This document details definitions, methods of measurement, and minimum electro4 acoustic performance characteristics for Code Division Multiple Access (CDMA) mobile stations. These standards are intended to ensure a level of electro-acoustic performanc

Electro-Acoustic Recommended Minimum Performance Specification for cdma2000 Mobile Stations

UL 1863-2004 通信電路附件

1.1 These requirements cover telecommunications-circuit accessories, such as jack and plug assemblies, quick-connect terminal assemblies, telephone wall plates, telephone extension cords, cross-connect terminal-block assemblies, maintenance terminal modules, terminal enclosures, cable-splice enclosures, network-interface devices, wire-guide assemblies, and connector boxes. 1.2 These devices are intended to be used in telecommunications networks that have an operating root-mean-square (rms) voltage to ground less than 150 volts and installed or used in accordance with the National Electrical Code, ANSI/NFPA 70. 1.3 These requirements do not cover telephone equipment such as telephone answering devices, residential telephone instruments, telephone dialers, cordless phones, key systems, and private-branch exchange equipment that is covered by the Standard for Information Technology Equipment – Safety – Part I: General Requirements, UL 60950-1. Also, these requirements do not cover: a) Telephone protectors that are covered by the Standard for Protectors for Paired-Conductor Communications Circuits, UL 497, and b) Secondary protectors that are covered by the Standard for Secondary Protectors for Communications Circuits, UL 497A. 1.3 revised May 14, 2004 1.4 These requirements do not cover receiver/transmitter-type devices. Equipment of this type is covered by the Standard for Audio-Video Products and Accessories, UL 1492, or the Standard for Audio/Video and Musical Apparatus for Household, Commercial, and Similar General Use, UL 6500. These requirements do not cover cellular telephones or cellular devices. Equipment of this type is covered by UL 1492. 1.4 revised May 14, 2004 1.5 These requirements may be used, directly or by reference, to investigate portions of other equipment, not classified as telecommunications-equipment accessories, that may be connected to a telecommunications network, insofar as they may be applicable to such equipment. 1.6 These requirements do not cover wires and cables intended to be permanently installed in a building in accordance with Article 800 of the National Electrical Code, ANSI/NFPA 70.

Communications circuit accessories

DLA MS39030 REV A VALID NOTICE 2-2003 (電桿上線路)扁平橫木拉線

MS39030A remains inactive for new design, however, the document is valid for use.

BRACE, CROSSARM, FLAT (POLE LINE)

CSA C22.2 No.65-03-2003 接線器.第1次修訂.第2次修訂

Revisions of this Standard will be made by issuing revised or additional pages bearing their date of issue. A UL Standard is current only if it incorporates the most recently adopted revisions, all of which are itemized on the transmittal notice that ac

Connecteurs De Fils Mise No 1; Mise No 2

DLA MS35760 REV A NOTICE 2-1999 (CD-307-A型軟線)軟線組裝

MS27417A is inactive for new design and is no longer used except for replacement purposes.

CORD ASSEMBLY, ELECTRICAL (CORD CD-307-A)

DLA MIL-J-5251 A NOTICE 3-1999 U-82/U塞孔

MIL-J-5251 A is inactive for new design and is no longer used, except for replacement purposes.

JACK U-82/U

TIA TSB31-B-1998 第68部分 基本原理及測量指南

Part 68 of The Federal Communications Commission (FCC) Rules and Regulations (Ref Al 7) contains the minimum technical standards that Customer Premises Equipment (CPE) must meet in order to be directly connected to the telephone network. These rules specify those technical standards necessary to assure that CPE will not cause harm to the telephone network.

Part 68 Rationale and Measurement Guidelines